The marine 6008A 8-channel amplifier delivers a powerful 75-Watts RMS to each of the front and rear speakers in your boat. You can also bridge the amp to 2-channel mode to drive a couple subs with 250 watts RMS or 3-channel mode to drive both a pair of full range speakers and a subwoofer. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your marine's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics.
Compact size
Infinity amplifiers have been engineered with a compact footprint to fit in more boat even if available space is limited.
Input Level Control
Marine 6008A-When low-level inputs are used, this control adjusts the input sensitivity between 200mVrms and 5Vrms. When high-level inputs are used, this control adjusts the input sensitivity between 1Vrms and 25Vrms.
Phase Switch
This switch changes the input phase to inverted or non-inverted. This is especially helpful with the subwoofer channel.
RBC wired remote
The RBC wired remote is an easy installation and can be mounted for convenient volume adjustment from driver's seat.
Turn-on mode
This switch changes DC to REM to adapt with low-level signals or high-level signals, this is especially helpful as part of remote turn-on lead of your installation more choice. A selectable "Turn-on mode" can protect battery to avoid current drain, when you don't expect turn on your amplifier.
INPUT Mode
Multiple switching: Switch to 2 Ch: To control RCA inputs from #1 and #2 channels:
- The audio signals from input #1 will be transformed to output #1, #3, #5 and #7;
- The audio signals from input #2 will be transformed to channels #2, #4, #6 and #8. Switch to 4 Ch: To control RCA inputs from #1, #2, #5 and #6 channels.
- The audio signals from Inputs #1 will be transformed to output #1 and #3;
- The audio signal from #2 will be transformed to Channels #2 and #4;
- The audio signals from Inputs #5 will be transformed to output #5 and #7;
- The audio signals from Inputs #6 will be transformed to output #6 and #8;
Switch to 8 Ch: Each of all inputs are transforming its corresponding output #channel.
